Main ingredients: pure water, pure taste emulsion, marble powder, nano calcium carbonate powder

Coating area: Edinburgh (flat batch + rub) bottom material: 1.25-1.4m² / L; fabric: 10m² / L

Recoating time (at 25 ° C): surface dry: 2 hours Hard dry: 48 hours Recoating: 4 hours later

Construction preparation: Material: Hand wax (plain + metallic)

Construction Tools: Tools: Batch Knife, Sponge, Stencil Mold, M75 Adhesive

Construction method:

1. Use "Edinburgh" to batch the first pass, dry and then batch, and scrape the polished surface to create a rugged texture.

2. Customized printing style, plan the printing position on the wall, fix the enamel printing board with textured paper (or manual fixing, M75 self-adhesive), then fill it with “Edinburgh” thin batch, and take it off immediately after completion. Printing mold.

3 .Use a fine sandpaper (about 240~600 mesh) to slightly polish the surface to remove dust.

4. Rub the antique color, make a single color or two colors, and evenly rub it with a sponge ball. If coloring is required, repeat the rubbing twice.

Storage: Store in a dry and ventilated place at 20-35 °C. Keep the remaining materials sealed.

Shelf life: 12 months

Note (Please pay attention to the following 4 points):

1 .Temperature ≤  5 ° C, relative humidity ≥ 85% can not be applied.

2. It must be sanded when it is dry, and dustproof masks should be worn when sanding the wall.

3. Read the construction instructions before use to obtain a reliable and satisfactory coating effect.

4. For detailed information, or any construction issues, please contact Mantu.